Next check and clean the furnace’s flame sensor. The video below shows you how—note that this guy fixes it in about 5 minutes. We would probably use a little bit of emory paper, but he cleans the sensor with a 5-dollar bill. Another video further down the page under the discussion of “If your furnace keeps shutting off after about 5 minutes” shows the same project with a different brand of furnace.

For nearly 60 years, Metro Heating and Cooling has been the premier choice for furnace repair Pittsburgh homes and businesses rely on to keep them warm throughout the coldest winter months. Furnaces are subject to wear and tear from normal use over the years, and if a unit is not properly and regularly maintained, it is likely that it will need to be repaired in some capacity. Whether you are just beginning to suspect there is an issue with your heater and need a minor repair, or if your heater has stopped working entirely, leaving you in the cold, we can help! Our skilled team will get your home or business restored to a warm and comfortable environment. Regardless of when your furnace stops working, we offer 24/7 emergency services for your convenience. Contact the experts at Metro Heating and Cooling today!
We know that furnace breakdowns can happen at any time. As a full-time heating contractor, we keep abreast of current technologies and, as a result, our technicians are able to install or repair any heating system efficiently and in a timely manner. Whether you need furnace repair or installation, well-qualified Atlanta-based technicians are available to meet your needs.
This job involves removing the access panel, loosening a couple of bolts that hold the blower motor at the proper tension, and adjusting its distance or realigning the belt. In many cases, it’s a good idea to remove the belt and buy a replacement at a home center. Last, when reinstalling the belt, be careful not to over-tighten it; this can wear out the motor bearings.

• If your furnace is inside the house, it may be located in an area that is magnifying the sound it makes – such as under a staircase. Often moving the furnace to another part of the house can reduce that noise. You may find that it’s in an area that was previously occupied by another older type of furnace, and you never heard those sounds from that one. Please keep in mind that modern furnaces are built differently – with multiple speeds and stages – which may create different sounds and require more airflow than your old ductwork has available. If the furnace doesn’t get enough air, it gets cranky.
Whether you are looking for gas furnace service or repair, quality installation of a furnace, heat pump or air conditioner, mini split ductless heat pumps, endless hot water from tankless water heaters, better air quality in your home or just a filter change or duct cleaning, Greenwood Heating is your best choice of Seattle heating contractors and cooling specialists.
There are a lot of problems you may encounter with your water heater, but there are also a lot of warning signs that can tip you off to the fact that repairs are necessary. Unreliable or insufficient hot water, as well as increased hot water costs, are among the most common. Give us a call to ensure that your water heater repair in Kirkland, WA is completed promptly.
Vredevoogd Heating & Cooling invites you to research our good name. Read customer testimonials and call to discuss your service needs with our staff at any time. We provide service with minimal interruption to your home. We perform careful diagnostics and apply expert fixes for all your service needs. Because your HVAC system is essential to your home and a major investment, we encourage you to contact us for professional installation. We have 54 years of experience fueling our HVAC know how. Don’t trust your heating and cooling needs to just anyone. Let Vredevoogd Heating & Cooling Grand Rapids MI handle all your HVAC maintenance and installation needs.
Lennox was started to provide some of the most dependable, reliable HVAC systems in the field while providing great service and quality for customers. B & B Heating & Cooling in Florissant is no different, with our constant devotion to your comfort and commitment to the community. We strive to be the best at what we do so you can always be comfortable, and know you can always depend on us. Give us a ring at 314-838-9800 or schedule an appointment with us so we can help you achieve whole home comfort. 
When’s the last time you had your home’s heating system maintained? If you’re like most homeowners it’s probably been a while, but keeping your plumbing, heating, and cooling systems under control is vital. That’s where Anthony Plumbing, Heating and Cooling comes in. We’re the best in HVAC Service in Kansas City, MO when it comes to keeping your systems running and your family comfortable. Our company was founded in 1951 and we’ve been providing quality services in Kansas City ever since.We service and do repairs in the following: Kansas City KS Furnace Repair Air Conditioning, Plumbing
The national average for furnace replacement is between $1,800 and $2,500. The cost can range dramatically higher depending on the model of furnace you select, any repair work you require, your location and the cost of installation. Furnace installation costs can be more than the furnace itself due to the cost of doing business and the expertise needed to install the HVAC equipment. Installing a new furnace generally requires technical know-how and the proper tools and licensing. It’s best to hire a pro and budget for furnace installation rather than risk potentially unsafe DIY installation. This will ensure your home’s safety. Check to see if your HVAC contractor has the proper licensing to do the job. If you need duct repair or replacement, expect to pay more for your furnace installation costs. The price for duct repair could be an hourly rate ranging on average anywhere from $85 to $150 per hour, with additional costs for parts.

When your furnace isn’t regularly serviced it can operate less efficiently. This increases your energy bills and also prevents your furnace from keeping your home as warm as you like. Keep your furnace properly maintained with regular service. The national average furnace service cost is between $60 and $80. Companies may offer tuneup specials that cover all the necessary testing, tightening, measuring and cleaning to keep your equipment running at top efficiency. If you have a newer system, furnace service costs may be covered by your warranty. Outside of warranty, a basic tuneup might start at $58 and a more advanced maintenance cleaning could be over $120. Here are some signs your furnace may need service:

Metro Heating & Cooling is a family owned and operated business, and we have been providingPittsburgh heating and cooling services and products since 1957. As a family owned and operated company, we take the term “customer service” to a whole new level, because we genuinely care about our customers’ needs and comfort. Our goal is to ensure your home or business has an HVAC unit that runs flawlessly in every aspect of the system, heating, cooling, and ductwork, and provides you with clean and comfortable air during the entire year. Another benefit of having heating and cooling services provided by a family owned and operated business is that the staff is consistent, well-trained, and has vast experience due to being with the company for many years. We are thankful for our exceptional staff that has kept the quality and reputation of our work unwavering over the years. To experience the difference with Metro Heating & Cooling, contact us today!
If your heater is relatively new, we will be able to repair it. If your furnace is antique, we will fix it if it can operate safely. The HVAC technician can check for cracks in the heat exchanger. Cracks can leak dangerous exhaust fumes into your living space. Sometimes, repairing a damaged furnace is more expensive and less efficient than replacing it.

An annual inspection of your unit can ensure that the various potential problems mentioned above are detected early, and before they require complete replacement. During this inspection, for instance, a professional might find small cracks in your heat exchanger or a faulty seal in your blower motor. Some manufacturer's warranties even require these annual inspections to maintain validity. Typically, your furnace inspection will cost between $80 and $150 depending on the area in which you live and the professional you work with.
Regarding your post, Every technician performs a maintenance differently. Today's modern furnaces really don't require as much maintenance as older style systems did. For instance: Older furnaces had drive belts, pulleys and motors with oil ports.Today's blowers are direct drive no belts, no pulleys, sealed bearing motors no oiling required. All of the new modern technology cuts the maintenance time in half if not more. Today's equipment has multiple safety's in place so that in case of a failure the system will shut down. non serviceable control boards or (Brains) monitor system functions. Unlike oil systems, the maintenance on a gas system can possibly be completed in less than half the time. I'd say 20 to 30 minutes is about right unless a service issue arises. In the 30 minute time span, the doors can be removed, system components can be visually inspected, the flame can be inspected and co test can be performed for spillage and vacuum of the combustion area can be performed if needed. The air filter should be checked and the humidifier can be activated. Remember that probing into a perfectly functioning system can be detrimental to its lifespan. My advice is change you air filter, keep the area around the equipment free of dust and try not to store in close proximity to the heating plant. Be sure you have an updated quality carbon monoxide detector in your home. Regarding the crack in your heat ex-changer, If the heat ex-changer had a crack in it, the system it should have been shut down right then and there. Be aware that Carbon monoxide may be entering your living space due to that crack. Have a knowledgeable company come back and do a CO test in your home at the supply vents and use a scope to check your heat ex-changer for cracks. I hope this helps you. Bottom line, you have to trust the company that you are using. If you feel uncertain about their capabilities, then more than likely, you instinct is correct. Good Luck to you.. Happy Holidays

“The manufacturers that built them all agree on this; you should get it serviced once [a year] for heating and once for cooling," says Paul Mills, owner of Air Experts Heating & Cooling in Raleigh, North Carolina. "Tuning it up and checking it out is definitely recommended. Much like a car, if you ignore it, a lot more things break. You [will] extend the life of it and help prevent major breakdowns.”

One great way to improve indoor air quality is with professional air duct cleaning in Kirkland, WA. If you have a lot of pollutants building up in your air ducts, your ductwork can then circulate those pollutants throughout your entire home. This means that your whole house can be contaminated by the ductwork which is supposed to keep it comfortable.


Metro Heating & Cooling is a family owned and operated business, and we have been providingPittsburgh heating and cooling services and products since 1957. As a family owned and operated company, we take the term “customer service” to a whole new level, because we genuinely care about our customers’ needs and comfort. Our goal is to ensure your home or business has an HVAC unit that runs flawlessly in every aspect of the system, heating, cooling, and ductwork, and provides you with clean and comfortable air during the entire year. Another benefit of having heating and cooling services provided by a family owned and operated business is that the staff is consistent, well-trained, and has vast experience due to being with the company for many years. We are thankful for our exceptional staff that has kept the quality and reputation of our work unwavering over the years. To experience the difference with Metro Heating & Cooling, contact us today!
Many homeowners don't often think of the state of their furnace—that is until, the first cold day of the year comes around and the furnace won't turn on or only blows cold air. Keeping an eye out for common signs of trouble can help you avoid a complete furnace breakdown. Addressing any issues early on can also help you avoid most extensive (and therefore, more expensive) repairs down the road.
If your furnace has a pilot light, look for the flame. Check your owner’s manual or the instructions posted inside the furnace cabinet for step-by-step lighting instructions. Usually this involves first turning the gas valve to Off and waiting a couple of minutes. Then you turn it to Pilot. Next, press and hold it down while you light the flame. Last, wait a minute or so, release it, and then turn it to On.

There’s a common misconception that you can save money by shutting the vents (supply registers) in rooms that aren’t being utilized. Resist the urge to close too many, as doing so can actually increase the pressure in your furnace, making it work harder to heat your home. This can lead to failed blower motors, mold or mildew in your ductwork, damage to the compressor, a cracked heat exchanger, and other problems. What Does a Furnace Tune-Up Include?
In a lot of homes, in Chicago Illinois, the initial HVAC installation was banged together to get it done. We’ve found big errors in heat system installations, like heat registers that aren’t hooked up and ducts that are open and pumping heat into your crawlspace or attic, or thermostats installed in the wrong place. Our Heating system technicians can survey your HVAC system and suggest improvements that will improve your comfort and save you wasted fuel bills.
If your furnace sputters to a halt during the evening or overnight in the middle of winter, you can bet that the indoor temperature will plummet by morning and everyone will be cold and uncomfortable. It isn’t as bad as outside because you have wind protection and residual heat, but no one in the house will be happy. The key to finding a quick solution to these kinds of scenarios is to align yourself with a reputable, reliable service provider before there is a problem. If you have a local expert in your corner, you can call as soon as something happens and your service disruption will be minimal.
Vredevoogd Heating & Cooling Grand Rapids values each and every customer. Servicing or installing your HVAC system means establishing a service relationship with each homeowner. We promise to earn your trust with our consummate level of professionalism and expert service. We back our work with the strongest industry guarantees because we value your continued business.
Do not try to do DIY gas furnace maintenance or tune-ups yourself. In addition to being dangerous, this may also violate the manufacturer’s warranty. Let properly trained and experienced technical staff perform all gas furnace preventative maintenance. Regardless of your DIY talent, trying DIY furnace maintenance is fraught with hazards and risks to your heating system—and yourself.
When your furnace filter becomes dirty, dusty and clogged, you can expect some negative effects on your furnace efficiency and your indoor air quality. The forced air is supposed to get blown through the filter and the filter is supposed to trap any particles so they don’t end up in your air ducts and throughout the house. When the filter has trapped too many particles and it is clogged up, the air keeps blowing, but some of those trapped particles will end up in the system and your living space. Another effect is that the furnace has to work harder to get the same amount of air through that dirty filter, so your heating bills may go up.
Cleaning the debris that builds up on your filters will aid with the flow of air. When your air filter is clogged, your air handler must work harder to compensate for the blockage of air flow. In addition to driving up your utility bill, the reduced air flow through your heating and cooling system can cause your heat exchanger to overheat and shut off too quickly.    
×