As a Carrier Factory Authorized Dealer, M and M, Heating & Cooling, Plumbing & Electrical is qualified to properly size and install the most technologically advanced and well-regarded heating, cooling, and air quality products on the market today. Our team is NATE-certified, factory trained, EPA certified, and regularly updated, ensuring the right solution to any challenge.
When it comes to heater repair in Denver, a properly serviced system means significant savings for the homeowner. When a Denver heating technician inspects your system before the winter sets in, the first thing they will check is the condition of the air filters. These filters are important, because they are responsible for removing contaminants, allergens, and dust particles from the air every time the system is turned on. When the filters are clogged, expect more particles to easily pass through right into the air you breathe inside the home. The Denver heating experts will inspect and replace any filters that are no longer effective.
The thermocouple is a copper rod that the pilot flame heats-up. When it gets hot enough, the thermocouple signals that there is enough heat to burn the gas fuel being released into the appliance—and so it allows the gas to be released to the burners. In some cases where the pilot light won’t stay lit, the thermocouple needs to be adjusted or replaced. This is generally a job for a professional.
We provide superior heating and cooling service and repair as well as HVAC system maintenance, repair and duct cleaning services. For over 20 years, Ballard Natural Gas Service has provided the highest quality services for your home. You can take comfort in knowing that we will treat your air conditioner, furnace, water heater, ducts or gas fireplace the same way we would treat our own, with the best care and highest quality professionalism. We treat you like family.
Your HVAC system is an important appliance with a limited lifetime. Depending on use, with regular maintenance you can expect your furnace and air conditioner to last between 8-18 years before you will need to replace the old one. However, poor maintenance is one of the primary reasons for early replacement HVAC systems ahead of end of average life expectancy.
"During the winter, all the air that your family is breathing comes through this filter," says Richard. "You can't change it too often, but never let it go for more than a year." Changing the filter is something any homeowner can do easily. At the same time, Richard checks the blower belt's wear and tension. (The blower, driven by an electric motor, moves heated air from the furnace through ductwork to room vents.) A loose belt can slow the blower, compromising efficiency. If the belt deflects more than ¾ inch when pressed firmly, it can be adjusted by sliding the motor backward slightly.
Before performing DIY furnace maintenance, Richard makes sure to switch off the electrical power and the fuel supply. The distinctive red power switchplate can usually be found at the top of the cellar stairs or near the burner itself, while the fuel shutoff valve is near the oil tank or on the incoming gas pipe. Note the location of both in case of a future leak or fire.
Our technicians have experience repairing furnaces and will make sure your home is back to keeping you warm and cozy in no time. From training and certifications to our reputation for getting the job done right time and time again, you can trust that House of Heating Incorporated’s furnace repair technicians will have your problems taken care of and your furnace working smoothly. Whether it’s emergency furnace repair or service you can schedule in advance, our team can provide you peace of mind, knowing that your furnace is in skilled hands. Do you need furnace repair? When performing a repair, it's vital to hire professional HVAC contractors.
Ultimately, the cost to repair your furnace depends on a wide range of variables. From the brand of the units to the damaged or broken parts, you need a reliable and trusted professional who can evaluate the issue and recommend next steps. If you're unsure whether to repair or replace your furnace, or even where to begin, connect with a local furnace repair professional who can make sure that your home heats well both now and in the future.
You can, however, avoid many serious damages to your AC by scheduling your air conditioning repair as soon as you notice a problem with your system. No irregularity is too minor to contact a professional Kirkland air conditioning repair technician about. The longer you wait to schedule AC repair service, the more likely it becomes that your system will be seriously compromised.
Yes. You should expect to pay a diagnostic fee to cover the cost of the technician's visit, the diagnosis of your air conditioner's problem, and a quote for the repair options. You will be advised of the issue along with recommended options to correct it, which may include a system replacement if your unit is old or significantly damaged. If you decide to replace the system, the diagnostic fee will be credited toward your replacement purchase.