Another energy savings tip, HVAC professionals say, is using a programmable thermostat. A programmable thermostat can save you up to 10 percent on energy bills, if you dial it down seven or eight degrees from the normal temperature setting — the U.S. Department of Energy recommends a setting of 68 degrees — for eight hours a day, whether it's during the work day or at night, according to DOE.


I was disappointed with the pressure of a tub and shower that were plumbed with 1/2 supply lines (2nd floor). Could be low pressure from the street, but I want to replace with 5/8. Plus, I'd like to have 2 back to back showers, one inside and one outside. So, I had intended to bring a 1 supply to both, then branch up to valves and shower head with 5/8. Finally, I thought pressure from the street was typically 55 to 70 psi and I am concerned if pvc can take that.Any thoughts?
If you need a furnace repaired or an air conditioner serviced, we'll send a local technician out to diagnose the specific problem and recommend solutions for you and your family. There will be a diagnostic fee for the visit, and any specific repairs will be an additional charge. If replacing your system is the best solution, the fee for the diagnosis will be credited toward the purchase and install of a new system.
If your heating system in Everett, WA is not working it is likely your furnace needs repair or service. At times the fix is simple, other times it is not. Our heating and furnace service technicians have years of experience working on furnaces like yours in Everett, WA. C.M. Heating has service vehicles on call that are fully equipped with the tools and parts necessary to get your furnace back up and operating. 

There are a lot of problems you may encounter with your water heater, but there are also a lot of warning signs that can tip you off to the fact that repairs are necessary. Unreliable or insufficient hot water, as well as increased hot water costs, are among the most common. Give us a call to ensure that your water heater repair in Kirkland, WA is completed promptly.
CM Heating performed an electric furnace Diagnostic - Upon investigation, I found that the sequencer has failed which is why all heat elements are not being activated (3 out of 5 work). This is the second replacement sequencer needed in less than 5 years of operation, the unit is an old model of air handler and only source of heat. Replacement of sequencer is needed, however, based on age and efficiency recommend upgrade of system.

At Horizon Services, we strive to go above and beyond for every one of our clients. We offer honest, upfront pricing in writing for every service we provide, as well as flexible scheduling to suit your needs, industry leading warranties, and a 100% customer satisfaction guarantee. When you call on us for heating services, our technicians will arrive on-time, every time. If we're even one minute later than the provided window of time, you don't pay. We understand that dealing with a broken or malfunctioning heating system can be incredibly frustrating. Let us turn your stressful situation into a thing of the past!
The national average for furnace replacement is between $1,800 and $2,500. The cost can range dramatically higher depending on the model of furnace you select, any repair work you require, your location and the cost of installation. Furnace installation costs can be more than the furnace itself due to the cost of doing business and the expertise needed to install the HVAC equipment. Installing a new furnace generally requires technical know-how and the proper tools and licensing. It’s best to hire a pro and budget for furnace installation rather than risk potentially unsafe DIY installation. This will ensure your home’s safety. Check to see if your HVAC contractor has the proper licensing to do the job. If you need duct repair or replacement, expect to pay more for your furnace installation costs. The price for duct repair could be an hourly rate ranging on average anywhere from $85 to $150 per hour, with additional costs for parts.

The fully licensed and insured, NATE-certified team from Marky Mark's Heating, Cooling & Plumbing, LLC is always available when you experience a problem with any make, model, or style of HVAC or plumbing system.  We offer 24/7 Emergency Repair in Thornton, CO & Westminster, CO and throughout the Northern Denver Metro area, handling residential and light commercial application, arriving promptly and prepared to complete the majority of issues in a single visit.
North Winds Heating & Cooling is an Okemos-owned full-service HVAC company that is available for all your heating and cooling needs in Lansing and the surrounding cities. We proudly serve the Greater Lansing area with a complete range of heating & cooling services – including residential, commercial, and industrial. Our  HVAC technicians have over 30 years combined experience in the heating and cooling field and will treat your repair or installation job like it’s their own. Our experienced HVAC team has the latest diagnostic tools and equipment needed to perform a variety of services that we offer such as air conditioning installation & repair, furnace repairs, and HVAC maintenance. 
Advice you can count on – When you have an emergency, you are not always in the position of asking questions to determine if the repairs you are receiving are what you need. At Jennings, our NATE Certified technicians will walk you through the repairs and explain why you need them. You can trust that everyone on Jennings’ staff will give you honest advice.
Vredevoogd Heating & Cooling Grand Rapids employs more than 80 people who are proud to work under the Vredevoogd Heating & Cooling banner. Each team member shares our company values for service excellence. All of our employees are intensely screened and background checked so that you have peace of mind when they enter your home. Moreover, our technicians are certified to work in the HVAC industry and provide the level of expertise that our customers expect from Vredevoogd Heating & Cooling. We back our technicians’ work and continue to make training a priority so that all of our techs are familiar with the latest HVAC models and advances. Our customers deserve the best, so the best is what we deliver to each and every job.
With our furnace service, your burners will be pulled and cleaned. To ensure the best possible efficiency, we can adjust your heat-off delay. You can also expect a combustion analysis performed by a professionally certified HVAC technician. With a proper combustion analysis, we’ll be able to tell you if your furnace is operating at maximum efficiency and keep you safe.
When the time comes to schedule furnace repairs, you want a team you can trust. Keeping your home warm and comfortable is important for you and your family, which is why you should rely on the highly-trained team of technicians at Horizon Services. Our techs undergo at least 150 hours of technical training every year and are up-to-date on the latest, most advanced techniques in the trade. We also background-check all of our employees to ensure your complete comfort and safety. When you call on us for furnace repair, we will arrive on-time and on schedule, ready to resolve the issue as quickly as possible.
Whether its gas pressure that needs adjusting or an inducer fan motor that needs replacing; We offer a 100% customer satisfaction guarantee for everything that we do. You never have to hesitate to contact Signature Heating, Cooling & Plumbing at 505-365-1885 regarding your heating service needs. We service ALL brands! Financing is available for big jobs.
North Winds Heating & Cooling is your go-to Greater Lansing HVAC company for furnace repairs and installation this season! We take great pride in satisfying our customers and are committed to providing quality service at all times. Contact us today to learn more, need service, or to request a quote. Our location in Okemos makes us an excellent choice for repairs and services all throughout Greater Lansing towns including Haslett, DeWitt, Bath, East Lansing, and Grand Ledge. Our heating and cooling team looks forward to improving your lives one degree at a time. 
CM Heating performed a Gas Furnace Diagnostic. Customer wanted his echo bee thermastat installed that he had bought himself. Furnace was working fine just wanted his thermastat installed. He thought that the $99 service fee was going to cover that but explained to him what the service fee was for, and explained that there is a additional install fee for the stat. Customer didn’t want to pay the additional fee so I called the office had them listen to the call to make sure we explained to the customer correctly and to see how they would like me to proceed. So I quoted the customer the fee to install the thermostat but he didn’t want us to install it so I left.
Vredevoogd Heating & Cooling Grand Rapids values each and every customer. Servicing or installing your HVAC system means establishing a service relationship with each homeowner. We promise to earn your trust with our consummate level of professionalism and expert service. We back our work with the strongest industry guarantees because we value your continued business.
Call local Petro Home Services today to schedule a natural gas furnace tune-up by a professional technician. Our pros are qualified, experienced, and will perform a complete tune up, so you won’t need to worry that your furnace will heat your home efficiently this coming winter. You’ll also learn about preventative maintenance and furnace service plans, so you’ll be comfortable in your home all winter long.
Whether you’re looking to have a heat pump installed for the first time or think it’s time for an upgrade to your current system, Goettl Air Conditioning is the company to call. We offer a great lineup of Phoenix heat pumps and will make sure that the one we install in your home is the recommended match to your home’s dimensions and your family’s needs.
The national average for furnace replacement is between $1,800 and $2,500. The cost can range dramatically higher depending on the model of furnace you select, any repair work you require, your location and the cost of installation. Furnace installation costs can be more than the furnace itself due to the cost of doing business and the expertise needed to install the HVAC equipment. Installing a new furnace generally requires technical know-how and the proper tools and licensing. It’s best to hire a pro and budget for furnace installation rather than risk potentially unsafe DIY installation. This will ensure your home’s safety. Check to see if your HVAC contractor has the proper licensing to do the job. If you need duct repair or replacement, expect to pay more for your furnace installation costs. The price for duct repair could be an hourly rate ranging on average anywhere from $85 to $150 per hour, with additional costs for parts.
×