CM Heating performed a Gas Furnace Diagnostic. Customer wanted his echo bee thermastat installed that he had bought himself. Furnace was working fine just wanted his thermastat installed. He thought that the $99 service fee was going to cover that but explained to him what the service fee was for, and explained that there is a additional install fee for the stat. Customer didn’t want to pay the additional fee so I called the office had them listen to the call to make sure we explained to the customer correctly and to see how they would like me to proceed. So I quoted the customer the fee to install the thermostat but he didn’t want us to install it so I left.
Regarding your post, Every technician performs a maintenance differently. Today's modern furnaces really don't require as much maintenance as older style systems did. For instance: Older furnaces had drive belts, pulleys and motors with oil ports.Today's blowers are direct drive no belts, no pulleys, sealed bearing motors no oiling required. All of the new modern technology cuts the maintenance time in half if not more. Today's equipment has multiple safety's in place so that in case of a failure the system will shut down. non serviceable control boards or (Brains) monitor system functions. Unlike oil systems, the maintenance on a gas system can possibly be completed in less than half the time. I'd say 20 to 30 minutes is about right unless a service issue arises. In the 30 minute time span, the doors can be removed, system components can be visually inspected, the flame can be inspected and co test can be performed for spillage and vacuum of the combustion area can be performed if needed. The air filter should be checked and the humidifier can be activated. Remember that probing into a perfectly functioning system can be detrimental to its lifespan. My advice is change you air filter, keep the area around the equipment free of dust and try not to store in close proximity to the heating plant. Be sure you have an updated quality carbon monoxide detector in your home. Regarding the crack in your heat ex-changer, If the heat ex-changer had a crack in it, the system it should have been shut down right then and there. Be aware that Carbon monoxide may be entering your living space due to that crack. Have a knowledgeable company come back and do a CO test in your home at the supply vents and use a scope to check your heat ex-changer for cracks. I hope this helps you. Bottom line, you have to trust the company that you are using. If you feel uncertain about their capabilities, then more than likely, you instinct is correct. Good Luck to you.. Happy Holidays
Specializing in Bryant brand heating and cooling products, we offer a broad selection of innovative, industry leading technology to improve the comfort, health, and efficiency of your home or office. Our technicians are certified and highly trained to provide residents in Thornton, CO & Westminster, CO with unmatched heating and air conditioning services, including installation, repair and maintenance. Plus, our team of plumbers offers a range of indoor and outdoor plumbing solutions, including repair and installation of faucets, fixtures, water heaters and toilets, frozen pipe prevention and repair, and natural gas line service. Give us a call and take advantage of our proven dedication and prompt response.
Over the Labor Day weekend our hot water heater decided it was time to say good bye. Since we had our fall check the week before, we called Nerthlings. I cannot say enough good things about how this situation was handled. The technician, Dwain, was knowledgeable, friendly, and quite helpful without being pushy. Our questions were answered clearly. I am never made to feel that this is something...
Start with your utility company; they can help a great deal. Comparing previous bills isn't always a good measure, as the weather is never exactly the same month to month. Instead, if you take your energy bill and divide it by the square footage of livable space in your home, don't count areas like unfinished garages or basements -- you can calculate how much you are spending to heat or cool each square foot of your home. Your energy provider can tell you what the average cost per square foot is in your region for that same period of time so you can compare apples to apples.

If you invest in a sub par heating system then you can expect nothing more than a sub par performance from your furnace. Even so, it is possible to get a lousy performance from your furnace even if it is of the highest quality. That is because your furnace installation in Kirkland, WA is just as important to the performance of your furnace as the quality of the system itself.

B&B Heating & Air Conditioning is a Carrier Factory Authorized Dealer, a recognition that is earned rather than given.  Our service team is fully insured, certified, and receives ongoing factory training at the highest level. To further protect your best interests, our technicians do not work off commission.  We provide honest, ethical, and no-pressure service, and offer recommendations that serve your long-term satisfaction.

At Bob’s Heating & Air Conditioning, we believe that our customers deserve to live comfortably throughout the entire year. That is why we offer such a comprehensive selection of air conditioning, heating and water heater services in Kirkland, WA. When you work with us, you can rest assured that your furnace is installed properly, your AC maintenance is meticulous, and that your water heater repairs are top notch. Contact us today to learn more about the heating and cooling services we offer throughout Kirkland, WA.

Furnace Service Company CO

×